Tl-audio EQ-2 Manual do Utilizador

T L Audio User Manual EQ2 VALVE EQUALISER Tony Larking Professional Sales Limited, Letchworth, England. Tel 01462 490600, Fax

OPERATION. Front Panel. The front panel controls are identified in fig.3 Input Stage. Ensure that the correct input connector, mic or line, is

The filters have a cut-only response, to tailor the roll-off of the frequency response, forexample to' remove unwanted low frequency rumble

lu~wd!nb~ ~U!A'\°nOJ~q:l. qo:l.'ew 0:1. I~A~I :l.nd:l.no ~q:l. ~U!nOJ:l.UOO :l.SI~M 'I~A~I l'eu3'!S q~~ :I.'e :l.O~JJ

EQ2 Parametric Equaliser Technical Specification.Inputs: Line level balanced @ +4dBu nominal, via XLR sockets, plus unbalanced on jack sockets.Maximu

. -';)':)~ou }no~~ ;)~u~':) o} }':);)fqns ;)J~ suo~~':)m':)~ ;)Aoq~ ;)U'V A~£ @ AOa JO A~I I:S}U3W3.1!nb3.

SERVICE Should the equaliser require service, it must be taken or posted to an authorised dealer with a description of the fault. Please retain

INTRODUCTION The T L Audio EQ2 Parametric Valve Equaliser combines classic valve techniques with low noise solid state circuitry to produce a uni

The Stereo mode switch is a powerful facility, enabling precise tracking of equalisation between channels, with quick adjustment and no need to matc

INSTALLATION AC Mains Supply. The equaliser is fitted with an internationally approved 3 pin IEC connector. A mating socket with power cord and m

When using unbalanced signals, the signal ground may be obtained by linking pins 1 and 3 in the mating XLR connector. Good quality screened cable s

- Pin 2 = Signal Phase (“+” or “hot”), - Pin 3 = Signal Non-Phase (“-” or “cold”). If an unbalanced output is required, pins 1 and 3 should